cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
332
Views
0
Helpful
2
Replies

Question about etherchannel load balancing

Jason Dance
Level 1
Level 1

Hi fellow forum members.

 

In one of my networks I use etherchannel between my access layer (mainly 3750s) and distribution layer (6500).  Right now I am using a load-balance method of src-mac, and I'd like to switch to src-dst-ip. 

When I make the change, do both switches participating in the port-channel need to have the same load-balance method configured at the same time?  Or is it possible that I can change one first and do the other at a later stage?

 

Regards,

Jason

1 Accepted Solution

Accepted Solutions

Jon Marshall
Hall of Fame
Hall of Fame

Jason

Each end of the etherchannel can use whatever load balancing algorithm makes the most sense so no they do not need to match.

Jon

View solution in original post

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

Jason

Each end of the etherchannel can use whatever load balancing algorithm makes the most sense so no they do not need to match.

Jon

Thanks Jon, much appreciated!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card