cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7909
Views
0
Helpful
4
Replies

question about transport input command

nygenxny123
Beginner
Beginner

transport input telnet

will only allow telnet

transport input ssh

will allow only ssh

transport input telnet ssh

will only allow telnet and ssh

what will the default do?

as opposed to the transport input all?

1 Accepted Solution

Accepted Solutions

Richard,

You are indeed correct. That section of the documentation needs to be updated. It does mention in the 'Usage Guidelines' that the default 'none' applies to TTY connections but there is no mention of VTY connections.

I did a little digging and it seems the VTY connections default is set to 'all' but the documentation makes no mention of it.

__

Edison.

View solution in original post

4 Replies 4

Edison Ortiz
Hall of Fame Mentor Hall of Fame Mentor
Hall of Fame Mentor

is the default dependant on the IOS?

this is the running config from a cat switch.

it appears to be at default..

but if it was none, i shouldn't be able to telnet ..right?

line con 0

privilege level 15

line vty 0 4

privilege level 15

line vty 5 15

privilege level 15

yet i can telnet to it,

Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(35)SE5, RELEA

SE SOFTWARE (fc1)

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Thu 19-Jul-07 20:06 by nachen

Image text-base: 0x00003000, data-base: 0x00D40000

Richard,

You are indeed correct. That section of the documentation needs to be updated. It does mention in the 'Usage Guidelines' that the default 'none' applies to TTY connections but there is no mention of VTY connections.

I did a little digging and it seems the VTY connections default is set to 'all' but the documentation makes no mention of it.

__

Edison.

great thx!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers