Radius Authentication

[Arun Kumar Thakur]

I am trying to configure 802.1x RADIUS Authentication on cisco 2950-24TT-L Switch. I am using following set of command as given below

Switch# configure t

Switch(config)# aaa new-model

Switch(config)# aaa authentication dotx default group redius

Switch(config)# dot1x system-auth-control

Switch(config)# inter fasteth 0/1

Switch(config)#dot1x port-control atuo

I am faceing problem dot1x command is not working on interface. Kindly help me.

Amarjeet Singh

Chandigarh

[cadet alain]

Hi,

int f0/1

switchport mode access

dot1x port-control auto

Regards

Alain

Don't forget to rate helpful posts.

[stanly426]

Hi, cadet

Thanks for your replay!

It works and before I key in "dot1x port-control auto".

The running-configure shows the int is "authentication port-control auto".

But it works, thanks!