Is it possible to rate limit on a L2 trunk port on a 3750?
current port config and ios are as follows;
description *** Connection to Fiber Link ***
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,172
switchport mode trunk
i was wondering if the "srr-queue bandwidth limit 10" command would work to limit the output from this interface to be 10 % of the port bandwidth and then the same command could be done on the other side.
If so, is there anything else that I would need to do? If not, thoughts?
>> i was wondering if the "srr-queue bandwidth limit 10" command would work to limit the output from this interface to be 10 % of the port bandwidth and then the same command could be done on the other side.
To optimize the database description (DBD) packet exchange between two OSPF neighbors, use the compatible rfc5243 in router configuration mode or address family configuration mode for OSPFv3 AF. To disable RFC5243 optimization, use the no form of this com...
We said always that OSPF is a link-state routing protocol.For most engineer stuying CCNA or CCNP, OSPF is misunsdertanding.In reality, OSPF is a link-state routing protocol only within an area (intra-area); but almost a distance-vector routing protocol be...
A brief difference between ISIS and OSPF link state protocolsISIS and OSPF belongs to the same routing protocol family Link State, but if you study the two routing protocols, you will find several differences, in this article you will get the answer about...
The OSPF Type-2 LSA is one of the misunderstanding LSA among all the popular LSAs in OSPF , most people learns that this kind of LSA (Type-2) is generated by DR the Designated Router in a broadcast segment, for example when two or more than two routers ar...
Table of Contents
RADIUS has been the de-facto protocol for Remote Access Authentication for decades. RADIUS/UDP as defined by RFC 2865 has traditionally used MD5 for authentication and integrity. Unfortunately, successful attacks ...