02-21-2022 11:28 PM
hi i have cisco sw 3560 i want to break the password but the button mode is disabled i press Ctrl c and Ctrl break to corrupt booting from flash and inter to (switch:) mode and didn't work is there any solutions ?
02-22-2022 12:20 AM
Follow the below guide - (this will loose all config )
still an issue, connect console, post complete boot process.
02-22-2022 01:00 AM
the switch tells me when i start the sw
(the password-recovery mechanism is enabled)
the when i press mode button is still boot from flash
02-22-2022 01:32 AM
If the Mode button not working, you can use other method to to recover password (mentioned in the document) by pressing the breaking keys depends on the terminal client using.
check standard breaking key :
https://www.cisco.com/c/en/us/support/docs/routers/10000-series-routers/12818-61.html
switch: flash_init
switch: load_helper
switch: rename flash:config.text flash:config.old
switch: boot
after the switch boots and you are at the enable prompt, type this:
switch# rename flash:config.old flash:config.text
Switch# copy flash:config.text system:running-config
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide