06-13-2007 09:06 AM - edited 03-05-2019 04:41 PM
Hi all,
Working on recovering a 3750 switch...
Flash file system was formatted and then I copied the IOS bin file. No other files are on the flash file system. When the switch is reset if loads the IOS image and appears to successfully complete the POST and then ends off with the test below before "hanging" with a blinking cursor.
Top Assembly Part Number : 800-21980-01
Top Assembly Revision Number : F0
Version ID : N/A
Hardware Board Revision Number : 0x0B
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C3750-48P 12.2(37)SE C3750-IPSERVICESK9-M
Now there is no config.text file on this switch but I assumed this would be detected and I would be prompted to walk through the routine first time setup interview to get a basic config going but it just hangs...
Am I missing something?
TIA
06-13-2007 12:48 PM
Try uploading the IOS again through Xmodem and check
Narayan
06-13-2007 09:49 PM
Hi ,
follow the below procedure to load the IOS using xmodem.
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml
Thanks,
satish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide