reflexive access-list on 4500 switch

[Ahmed Shaier]

When I try to configure reflexive access-list on 4500 switch it gives me this error

% Reflexive ACLs are not supported on this platform

the switch is

WS-C4506-E with supervisior WS-X45-SUP6L-E

this is the ios image cat4500e-ipbasek9-mz.122-53.SG2

I checked the cisco feature navigator it says that it is supported on this ios on that platform.

So, does anyone has any idea what's wrong?

[Shelley Bhalla · Accepted solution]

This is Unsupported indeed.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_17886.html#wp998336

Unsupported Features:
The following features are not supported in Cisco IOS Release 12.2(46)SG1 for the Catalyst 4500 series switches:
•The following ACL types:
–Standard Xerox Network System (XNS) access list
–Extended XNS access list
–DECnet access list
–Protocol type-code access list
•ADSL and Dial access for IPv6
•AppleTalk EIGRP (use native AppleTalk routing instead)
•Bridge groups
•Cisco IOS software IPX ACLs:
–<1200-1299> IPX summary address access list
•Cisco IOS software-based transparent bridging (also called "fallback bridging")
•Connectionless (CLNS) routing; including IS-IS routing for CLNS. IS-IS is supported for IP routing only.
•DLSw (data-link switching)
•IGRP (use EIGRP instead)
•isis network point-to-point command
•Kerberos support for access control
•Lock and key
•NAT-PT for IPv6
•PBR with Multiple Tracking Options
•QoS for IPv6 (QoS for IPv6 traffic) (only applies to Supervisor Engines II thru V-10GE)
•Reflexive ACLs  <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
•Routing IPv6 over an MPLS network
•Two-way community VLANs in private VLANs
•CFM CoS