Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I try to configure reflexive access-list on 4500 switch it gives me this error% Reflexive ACLs are not supported on this platformthe switch isWS-C4506-E with supervisior WS-X45-SUP6L-E this is the ios image cat4500e-ipbasek9-mz.122-53.SG2 I chec...
I had the same exact issue and it turned to be the Content-Type header, here you have selected the body as raw and xml so the auto-generated Content-Type header will be application/xml and this what is causing the issue if you uncheck the auto-genera...
Hello Elliot,i know it is very late for answering after 6 years but I had the same issue recently and I spend a lot of time trying to fix it and i came through your post and i found no one replied so i think it is better to document the solution if s...
Dear,
This is always the case with SIP Phone in CME, you most probably you have forgot to do:
Voice register global
create profile
to apply the changes to the phones configuration files then you have to reset the phones to get the new configura...
You write a script to loop through the prompt for a defined number of times as you wish as the screen shot below
I have uploaded the script in the attachments, you can uploaded to the CUE and set the wavprompt variable to the prompt you will be us...
After a lot of struggle I finally did I used the instructions in this two videoshttps://supportforums.cisco.com/video/12155571/cucm-10x-samlsso-adfs20-installationhttps://supportforums.cisco.com/video/12155556/cucm-10x-samlsso-adfs20and this document...
