Removing policy-map not possible

[rwesel]

Hello,

I try to remove a policy-map I don't need anymore.

But I get an error message

switch(config)#no policy-map type control subscriber MONITOR_MODE_MAB_POLICY
%policy-map "MONITOR_MODE_MAB_POLICY" currently associated with at least one interface or template. Remove from interface(s) or template(s) first

The switch shows me a binding

switch#show policy-map type control subscriber binding MONITOR_MODE_MAB_POLICY
Policy Name Bound To Interface(s) 
----------- -------------------- 
MONITOR_MODE_MAB_POLICY Gi7/3

But the interface has no binding configured

switch#sh run int Gi7/3
Building configuration...

Current configuration : 247 bytes
!
interface GigabitEthernet7/3
switchport access vlan 106
switchport mode access
switchport nonegotiate
no cdp tlv app
channel-group 52 mode active
ip dhcp snooping limit rate 20
end

neither the port-channel

switch#show running-config int port-channel 52
Building configuration...

Current configuration : 120 bytes
!
interface Port-channel52
switchport
switchport access vlan 106
switchport mode access
switchport nonegotiate
end

I have this problem only on interfaces that are member of a port-channel.

Any ideas, how to remove this policy-map?

Thanks

Stefan

[Flavio Miranda]

Looks like something got stuck on the switch. I´d put the interface in default, shut it dow and try to remove the Policy.

Just an attempt. 

[rwesel]

Hello Flavio,

thanks for your hint. I forgot to say, that I tried this already. But no luck.

Maybe it's not so important to remove an unnecessary policy-map, but I wanted to clean up my configs.

Stefan

[Flavio Miranda]

And did you try with the PO as well? I mean, deleting PO, trying to remove the policy.  Maybe reloading between procedures.

[balaji.bandi]

what is the device model, and what IOS Code running?

Do you have an ISE environment ?  post-show run full config.

[rwesel]

Unfortunately, deleting the port channel as well as rebooting the switch is not possible.

[rwesel]

The switch is

WS-C4510R+E

Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500es8-UNIVERSALK9-M), Version 03.11.04.E RELEASE SOFTWARE (fc2)

[paul driver · Accepted solution]

Hello

---

@rwesel wrote:

Any ideas, how to remove this policy-map?

---

Scheduled a change window and either try shutting down the interface and PC or reload the switch.