cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
485
Views
0
Helpful
3
Replies

REPLACING MS390 WITH MS250

Sencyty
Level 1
Level 1

Hello guys am kind of new to Meraki, I need the best and most efficient way to replace MS390 Meraki switches in production with MS250. 

3 Replies 3

there is feature differences in these models. migration total depends on the features you have already configured in MS390. if you configured MS390 with some features which not doable in MS250,you need to find the alternatives first. then you can claim new MS250 switch to dashboard and do configurations without moving MS390 from network. after everything confirmed, you can connect new switch and remove MS390. but gain, you need to make sure all required features are configured and alternatives applied for non supported features.

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

balaji.bandi
Hall of Fame
Hall of Fame

Its straight forward, since both from Meraki the confg should support as expected.

configure online as same as old MS390.

what challanges you see here ?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

marce1000
VIP
VIP

 

  - You may also go here for that question : https://community.meraki.com/t5/Switching/bd-p/switching

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card