03-03-2022 07:09 AM - edited 03-03-2022 07:11 AM
I recently upgraded WS-C4507R+E and the other supervisor engine did not boot up. I requested a replacement through cisco RMA and it will arrive tomorrow.
I just want to know if we need to configure anything on the new supervisor engine.
PS: this switch is a standalone switch.
Thank you for your answers.
03-03-2022 07:13 AM
Do you single sup card or dual sup card in the same chassis ?
below guide help to replace (Hope you have config backup to restore ?)
03-03-2022 07:21 AM
Hi,
It's dual sup card on same chassis.
03-03-2022 07:23 AM
I was wondering if we still need to upgrade also the new sup engine even though the device is acting as Standalone.
03-03-2022 07:49 AM - edited 03-03-2022 07:55 AM
if the Dual sup - then the IOS Code should be the same as Primary.
this Cat 6500, most of the steps same :
03-03-2022 07:58 AM
- You may also verify module status-led in front of the box.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide