08-16-2010 02:43 PM - edited 03-06-2019 12:30 PM
I was recently configuring my Cisco 2911 router through a HyperTerminal session via USB connection. I noticed when I first connected it told me that there was a 1 time username and password (cisco, cisco) and I should change this or I would be locked out.... sure enough I did not change it and am not unable to log back in with those credentials.
What can I do to reset the system to its factory default or log into the terminal session again to setup the user credentials?
Solved! Go to Solution.
08-16-2010 03:21 PM
Password Recovery Procedure for the Cisco 2900 Integrated Services Router
http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml
Standard Break Key Sequence Combinations During Password Recovery
http://www.cisco.com/en/US/customer/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml
Hope this helps. Please don't forget to rate useful posts. Thanks.
08-16-2010 03:21 PM
Password Recovery Procedure for the Cisco 2900 Integrated Services Router
http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml
Standard Break Key Sequence Combinations During Password Recovery
http://www.cisco.com/en/US/customer/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml
Hope this helps. Please don't forget to rate useful posts. Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide