Switching

Hello:I was just having the doubt of the Voice over ip configuration. Not any switch that moves Vlan's, can move the traffic of voice right?This switches need to have the hardware and firmware that has the capacity of moving this kind of traffic. Tha...

Hi Gurus,Got a QoS question.On my 12000 series, i have the following config example for EF trafficpolicy-map Inter-Site  class NC    bandwidth percent 1  class EF    priority   police cir percent 80 bc 5 ms conform-action transmit  exceed-action drop...

I'm just getting started with Cisco and have a pair of 2950(s) with SFP ports cabled together. In order to do maintain/configure both switches from one or the other switch I need to establish communication through the SFP port. Otherwise I'm having t...

I have noted that, when I add a static route, if I put the exit interface, the static route is always added to the route table.Instead, if I put the next hop, it seems that the router checks if it can reach that next hop.If it is so, it adds the rout...

Hello,I uploaded my IOS version with supervisory 6-E, version 12.2 (40) SG to a version 12.2 (53) SG2.From what I read in the release, should also upgrade rommon version 12.2 (40r) SG1 to 12.2 (44r) SG5. In this case I don't because I have not found ...

Hi,I have a Cisco 827-4V with 16MB flash, but if i try to copy a file larger than 8MB it gives me an error that there is no space.But the 4 extra megas are there. I need this space to boot 12.4 IOS that are bigger than 8 MB.Does anybody knows what wo...

Hi all,For voice traffic what is GOLD CAR settings on the ISP Router.If we need to check these settings on the CE Router  how can we check that?thanksmahesh

Hi,We already have a couple of WS-C3750-48PS-S stacked together on our LAN. Would it be possible to add WS-C3750V2-48PS-S to the stack without encountering any issues. I intend to use the same IOS version and feature sets.Thanks

This is a very basic question.I have configured a 3560, vlan 1 with an IP address of 10.10.10.1, set fa0/1 to access vlan 1 I have set my laptop up with IP address 10.10.10.10, default gateway 10.10.10.1.From the laptop I can PING and Telnet into the...

Hi,I want to do LAB of SIA so any one can help me how I can perform the SIA.I want to see in topology table of EIGRP Active route and SIA status??

to defeat the "megaproxy" problem with ACE session persistence....I'm using the SSL-ID to perform sticky.  I'm using the \x20 in the layer-4 payload match.  Can anyone tell me if this is correct and what is the significance of the \x20? Thanks for an...

how do I create a private vlan ?

I have a Catalyst 3550 with PoE (WS-C3550-24-PWR) that has 1 x AP 1220 connected using PoE.  When I add 2 x AP 1242s, I get an insufficient power message.  How many devices using PoE can this switch support?  I'm running IOS v.12.1(19)EA1c - could th...