Router config

[skhirbash]

This is a simple one. how how I reduce the time so the the telnet session won't time out on me?

Also, how do I get the router not to display or echo a statement after I do any modification. For example, after I change the configuration on an interface, the router echos the following: *Nov 30 09:14:25: %SYS-5-CONFIG_I: Configured from console by cisco on console". How do I disable the router from displaying this?

Thanks in advance,

sK

[Collin Clark · Accepted solution]

For changing the telnet timeout. Try the following:

Router(config)#line vty 0 4

Router(config-line)#exec timeout 30

The 30 in the above statement is idle minutes before disconnect.

To remove any messages, type the following:

Router(config)#no logging monitor

HTH and please rate.

[Edison Ortiz]

Actually, the command is

no logging console

no logging monitor affects all monitored connections which include any SNMP logging traps among other things.

[skhirbash]

You are correct. The no logging monitor didn't work but the no logging cosole worked.

Thanks,

sK

[Collin Clark]

no logging monitor will shut off the messages during a telnet session and you got the console one figured out.