I just received a 1751 v router with WIC 2T installed in slot 1 and with th following vesion and flash:
[ROM: System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)
ROM: C1700 Software (C1700-BK8NO3R2SV3Y7-M), Version 12.2(8)T5, RELEASE SOFTWAR
System flash directory:
File Length Name/status
1 10679668 c1700-bk8no3r2sv3y7-mz.122-8.T5.bin]
I tried to configure serial subinterface via point-to-point using the following cmd : Router(config)#int s1/0.1 point-to-point and that does not applied, (this cmd is needed for frame relay DLCI configuration) .
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco...
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.