06-14-2011 05:12 PM - edited 03-07-2019 12:48 AM
As we know by default, routers are configured to receive any version of rip (1 or 2) updates.
If we manually set the version (version 1 or version 2) via config, this changes to version 1 or 2 respectively.
Can anyone tell me how I can get the router to receive any version of rip again without clearing configs and starting again. In other words, is there a setting that lets me do that?
Thank you.
Solved! Go to Solution.
06-14-2011 06:44 PM
06-14-2011 08:41 PM
If you want to send/accept either RIP Version 1 or 2 packets.
Router(config) # int e0
Router(config-if) # ip rip receive version 1 2
Router(config-if )# ip rip send version 1 2
06-16-2011 12:04 AM
Hi,
There is no global command to achieve what you want , the only global command concerning versions are:
-no version ---> default send 1 receive any
-version 2 ---> send and receive 2
-version 1 ----> send and receive 1
If you want other combinations you'll have to use the interface commands proposed above.
Regards.
Alain.
06-14-2011 06:44 PM
If you want to go back to default, then just type "no version"
HTH
06-14-2011 08:41 PM
If you want to send/accept either RIP Version 1 or 2 packets.
Router(config) # int e0
Router(config-if) # ip rip receive version 1 2
Router(config-if )# ip rip send version 1 2
06-15-2011 06:28 PM
Thank you both for your replies.
What I was after was a command I could give without doing it for each interface i.e. globally. Reza's "no version" command works.
Now here's a challenge (well to me it is anyway).
Default is as we know:
Router#show ip protocols gives...
Default version control: send version 1, receive any version
Now If I do Router(config-router)#version 2 :
Router#show ip protocols gives...
Default version control: send version 2, receive version 2
As I have learnt from your replies by doing Router(config-router)#no version :
Router#show ip protocols goes back to...
Default version control: send version 1, receive any version
How about if I want router to send version 2 updates but receive any version, in other words how do I get
Router#show ip protocols to give me...
Default version control: send version 2, receive any version
again, instead of doing it individually per interface (of course I know I can use the range command, but that's not what I'm after) a global command to do this. I look forward to your replies.
Thanks again.
06-16-2011 12:04 AM
Hi,
There is no global command to achieve what you want , the only global command concerning versions are:
-no version ---> default send 1 receive any
-version 2 ---> send and receive 2
-version 1 ----> send and receive 1
If you want other combinations you'll have to use the interface commands proposed above.
Regards.
Alain.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: