Routing on the 3560CG

[rasmus.elmholt]

HI

I have  a 3560CG, but when I enabled IP routing on it I got this error:

%PLATFORM_UCAST-3-INV_SDM: IP routing configured with invalid SDM template.

As far as i can see the platform does not support routing, but it that true.

It is a 3560CG-8PC with ipbase.

The current template is "default" template.
 The selected template optimizes the resources in
 the switch to support this level of features for
 8 routed interfaces and 1024 VLANs. 

  number of unicast mac addresses:                  4K
  number of IPv4 IGMP groups + multicast routes:    0.25K
  number of IPv4 unicast routes:                    0.875k
    number of directly-connected IPv4 hosts:        0.875k
    number of indirect IPv4 routes:                 0

Regards

Rasmus

[Mark Malone]

Hi

can you not change the SDM try below see what options you have ?

(config)#sdm prefer ?
  default          Default bias
  lanbase-routing  Lanbase routing

[rasmus.elmholt]

Hi Mark

Thank you for your reply.

I cannot change the SDM template

The SDM template used by Catalyst 3560-C Gigabit Ethernet switch is a default template and is not configurable.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/15-0_1_se/configuration/guide/scg3560/swsdm.pdf

Regards

[Mark Malone]

sorry compact you need ipservices as per doc

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3560-cx-series-switches/datasheet-c78-733229.html

Cisco Catalyst 3560-CX compact switches ship with the IP Base version of Cisco IOS^® Software. The 3560-CX switches can be upgraded to use the IP Services version of IOS Software with a right-to-use (RTU) License. The
IP Base and IP Services feature set on Cisco Catalyst 3560-CX switches provides baseline enterprise services in addition to all LAN Base features. They support Layer 3 networking features, including support for routed access, Cisco TrustSec, media access control security (MACsec), and other advanced network services. The IP Services feature set provides full Layer 3 routing capabilities with Open Shortest Path First (OSPF), Border Gateway Protocol (BGP), Enhanced Internal Gateway Routing Protocol (EIGRP), Policy-Based Routing (PBR), Multicast Routing, and Virtual Routing and Forwarding (VRF) Lite.

[rasmus.elmholt]

I have a 3560CX with the IP Services licens, and that one works great with OSPF without any problems.

The documentation says:

• IP Base: Enterprise-access Layer 3 switching, including Open Shortest Path First (OSPF) for routed access

But this is a 3560CG the old model of the compact switches, and not the CX models.

[Mark Malone]

the CG is available in ipservcies too and if ip routing is not on ipbase it will be on that same as the newer version CX , ipservices is the highest available image for those platforms all 3560s not just compact

https://supportforums.cisco.com/discussion/11785156/ios-update-3560-c-ws-c3560cg-8pc-s