Secondary core switch not pinging from multiple Vlan

[Haider Raza]

Hi Team,

i have configure two core switches with HSRP for multiple Vlan but primary core switch is pinging from all vlan but unable to ping secondary core switch from Vlans

Kindly suggest the configuration.

[Mark Malone]

should f0/4 on multi layer sw1 not be a trunk between the 2 switches , theres no config on it

is the hsrp fully formed can you post the show standby brief from each switch

[Haider Raza]

Primery_Core_Switch#sh standby brief
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Vl1 100 100 P Standby 10.1.227.253 local 10.1.227.254

============================================================
Secondary_Core_Switch#sh stand bri
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Vl1 100 100 P Active local 10.1.227.252 10.1.227.254

=============================================================

Hsrp fully formed ...and tell me what configuration should be done on both switch fa0/4 interface

[Deepak Kumar]

Hi,
I don't know your access switch configuration. Please attach the LAB.

Regards,
Deepak Kumar

[Haider Raza]

here is i attached the lab and will attached the access switch config.

[Deepak Kumar]

no issue with your configuration. Your interfaces are not connected properly.
Please share the Packet Tracer file for more investigation.

Regards,
Deepak Kumar

[Haider Raza]

Hi,

please find the attached packet tracer file and suggest the valid configuration for this lab.

Note : just convert this file from jpg file bcoz Pkt file is not sending over this link.

[Haider Raza]

hello,

have you checked my config 

[Deepak Kumar · Accepted solution]

Hi, There is some configuration issue,

1. HSRP is configured on VLAN 1 and its allowed on all ports. So some important port is blocked by STP.

2. It is taking time for ICMP reply because HSRP is not stable due to VLAN 1 configuration.

3. Duplicate IP assign on VLAN 2,3, and 4.
4. Preempt is configured on both devices and having the same priority in HSRP protocol. Change priority on one device to make a stable connection.

Please correct that's all things.
Regards,
Deepak Kumar

[motiar]

Hi Deepak,

I have an issue with the title

Re: Multiple Core c4500 Deployment

could you please have a look and suggest me with your experiences.

Regards

Motiar