02-24-2011 08:07 AM - edited 03-06-2019 03:44 PM
i copied security license file from tftp to flash on cisco 1941 router
it is installed but not enabled.
when i use
license install flash: security k9 .lic command it shows an error that %error installation failed udi cisco 1900 does not match any file in the system .
?????????what to do ????????
02-24-2011 08:09 AM
sh flash command shows that security license file in flash but not enabling
02-25-2011 12:49 AM
Are you 100% sure that the license is for this chassis? It might have been registered with another serial #.
Did you follow this guide:
?
Regards,
Ian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide