currently my network setup using a 4506-E core switches.Hsrp is running in between them.i have connected one websense server to the Active core switch and created a port mirroring on the same port.it is working fine.now the issue is when the core goes down i have to physically move that cable to standby switch.i want to make this process automatic.how do i do this.kindly share your ideas.
port config detail
Gi4/5
media Rj45
monitor session 1 source vlan 70
monitor session 1 destination interface Gi4/5
monitor session 1 filter packet-type good rx
end
