cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1930
Views
0
Helpful
3
Replies

SG200-08 Boot Code

Adam Hafner
Level 1
Level 1

I updated the firmware on two of the SG200-08 switches that I have, so both units are now running the 1.0.8.3 release of the firmware.  However, I noticed that the boot code versions on the two devices are not the same.  One is running 1.0.0.12 and the other is on D.8.3.1.  I was looking on the download site for the switches and the only download available is the firmware.  I don't see any files related to the boot code.  Is there someway to get the most recent boot code for these switches or at least get them both running the same boot code?

Thanks!

--Adam

3 Replies 3

Mark Malone
VIP Alumni
VIP Alumni

Try this link may help you

https://supportforums.cisco.com/discussion/11953536/sg300-bootloader-upgrade#4054032

Mark,

I saw this article when I was searching for a solution, but my problem is that on all the other posts they say that they have access to the 'rfb' file that would allow them to update the bootloader.  However, when I go to the download page for the SG200-08 that I have, there is no 'rfb' file available.  Just the 'stk' firmware file.  I am not sure where I can go to get the updated 'rfb' file to update the bootloader file via TFTP.  

If you go to this link it will list the only downloads available are for 'Smart Switch Firmware' 

https://software.cisco.com/download/type.html?mdfid=283454003&catid=null

and if you click on the link for the Firmware it takes you here, which lists the firmware and the language files, but neither of them contains an 'rfb' bootloader update file.  

https://software.cisco.com/download/release.html?mdfid=283454003&softwareid=282463182&release=1.0.8.3&relind=AVAILABLE&rellifecycle=&reltype=latest

Any suggestions on where I could download the 'rfb' file?

ye your right its not available for the 8 port but if you check the bigger switches its there like sg200-50

The only thing i can suggest is conatct these guys they should be able o help  with that

http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html