SG350-10p trunk port config for a cisco wireless access point? Anyone know why my access point doesn't light up?

[siteadmin@sleepyhead.co.nz]

Just wondering what the port config should be for a cisco wireless access point? Are there specific setting's needed for the cisco POE AP to be detected?

[Filip Knezevic]

No, you don't need any special port configuration. AP should pick up the DHCP IP.
Alternatively, you can try to configure it manually with console cable.

[siteadmin@sleepyhead.co.nz]

Thanks Filip, I'll plug the AP cable into one of the standard 'access' ports of the SG350 unit. Will let you know..cheers

[siteadmin@sleepyhead.co.nz]

Sorry just checked & its not picking an ip address via DHCP? but the AP is being detected by the switch? Weird?

[siteadmin@sleepyhead.co.nz]

Thanks Filip the AP is now picked up by the SG350 switch, however the only thing now is that the AP isn't appearing on our access point controller? Must be a setting I need to set on the SG350 switch?

[Filip Knezevic]

What region is the AP for? If there is a mismatch of a region it's licensed for it can create issues like this.

Did you try to connect to it via console cable and set the IP manually?