06-11-2009 07:08 AM - edited 03-06-2019 06:12 AM
Hi,
Does anyone know if there is a IOS command which displays all interfaces on a switch which contain input errors?
Regards, Peter
Solved! Go to Solution.
06-12-2009 05:20 AM
You can adjust your | command to include the interface.
sh int | i Fast|input errors
06-12-2009 06:30 PM
Hi Peter,
If you want the output which shows the interface and any line errors for the 6500 (IOS), try the command show interface counter error.
Does this help you?
06-11-2009 08:09 AM
Your subject line works!
SW#sh int | i input errors
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
06-11-2009 10:55 PM
yes, but it doesn't show the interface numbers. What I actualy need is a method to show all interfaces in a specific vlan containing input errors in a campus network of about 40 Cat.6500 switches.
I can use Kiwi Cat tools for it, but I need an effective IOS command to check for. Regards, Peter
06-12-2009 05:20 AM
You can adjust your | command to include the interface.
sh int | i Fast|input errors
06-11-2009 03:36 PM
Hi Peter,
You can also use the command "sh controllers ethernet-controller
Hope this helps.
06-12-2009 06:30 PM
Hi Peter,
If you want the output which shows the interface and any line errors for the 6500 (IOS), try the command show interface counter error.
Does this help you?
06-14-2009 02:49 PM
Thanks for the ratings, Peter.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide