Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1192
Views
7
Helpful
2
Replies

show mac address-table dynamic vlan 1 doesnt work

bade11
Level 1
Level 1

‎03-08-2019 05:02 PM

I would like use example 7-6 in the CCENT/CCNA ICND1 100-105 Official Certification Guide book.
This command doesnt work; show mac address-table dynamic vlan 1
sc6.PNG

Labels:
0 Helpful
2 Replies 2

Alan Ng'ethe
Level 3
Level 3

‎03-08-2019 05:05 PM

PT has a limited set of commands. Try show mac address-table dynamic. You may be able to see those learned off vlan 1.

Also, consider learning how to use GNS3
Remember to rate helpful posts and/or mark as a solution if your issue is resolved.

Deepak Kumar
VIP Alumni
VIP Alumni

‎03-09-2019 02:48 AM

Hi,
Again this is PT. I recommended going with a real device. You will get cheaper.

Regards,
Deepak Kumar
Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card