- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-11-2023 11:58 PM
hello Community,
I try to make the example 5-5 in chapter 5 : Analyzing Ethernet LAN Switching but the (show mac address-table dynamic with the interface Keyword) not working any one can help in that
Solved! Go to Solution.
- Labels:
-
LAN Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2023 12:02 AM
Packet tracer is a simulator , not real thing. Some commands are simply not available, not added, and behavior is not exactly the same as real ios.
You can try gns3, cml, eveng for more real lab environment
Regards, ML
**Please Rate All Helpful Responses **
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2023 01:31 AM
As motioned always have simulators some Limitation compare to physical devices.
So you can use what command available to verify with show commands. or get in to better emulator/simulators for some advanced features (not all supported)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2023 12:02 AM
Packet tracer is a simulator , not real thing. Some commands are simply not available, not added, and behavior is not exactly the same as real ios.
You can try gns3, cml, eveng for more real lab environment
Regards, ML
**Please Rate All Helpful Responses **
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-12-2023 01:31 AM
As motioned always have simulators some Limitation compare to physical devices.
So you can use what command available to verify with show commands. or get in to better emulator/simulators for some advanced features (not all supported)
