12-17-2012 12:00 PM - edited 03-07-2019 10:39 AM
I ran the Quick Config originally. Now I would like to change configuration but when I run Quick Config again the "Next" button is greyed out. How do I edit the port zoning using Device Manager?
05-25-2014 10:42 AM
Hello, I see that this question is really old, but I am faced with the same issue after upgrading my firmware to 5.2.8d on an MDS9124
Anyone know what the issue is?
05-27-2014 09:29 AM
For me the solution was to use the command line interface. It really is both easier and more reliable. Plus no Java.
05-30-2014 07:05 AM
Cisco support confirmed the issue: https://tools.cisco.com/bugsearch/bug/CSCuf39086/?reffering_site=dumpcr
While I agree that the CLI can be easier, for the zoning I preferred the simple GUI, since it provided an overview of what you're linking, and reducing chance on bad mistakes.
Anyway, thanks for your reply
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide