Switching

Hi ,I want to configure dhcp ip helper address globally on the cisco device.I google it but i found for assigning a particular interface. I need to configure IPhelper address globally . Please any one help me in that .Thanks in advance

How to make a cisco switch to support stack.Please help me in this.Thanks

Hi,I was studying about port-channel & ether-channel and found that, it can be bind up-to 8 ports. So maximum number, we can have of 8 ports or more ? For binding we should have minimum of 2 ports or 1 ports will work ? For load-balancing purpose, is...

All,I hope you are well and hope you can assistWe have a requirement where we have a number of Concession where we need to add them to a VRF.to avoid ACLs / the use of the global ruting table  (L3 segregation)In the drawing below the black line are t...

Hello, I have a pair of Nexus 7000 (NX-OS 6.2) in vpc domain, each of them equipped (in a vDC different from the admin one) with a Nexus 2248TP FEX.On the two fex I created a 4xGbE vPC (2 ports on each FEX) connected to an EMC DataDomain device, that...

Hi,will it work if i have a switch-to-switch connection with GLC-LX-SM-RGD on one end and GLC-LH-SM on the other end?

Does the Catalyst 3500 series XL FVS318 support POE

Hey Guys,I have two links on my router; R1 ----- MPLS -----R2 ------------------------------------------1st linkR1-----pt to pt -----R3------MPLS----R2 ---------------------2nd Link by default I am using 1st link and I would like to move to 2nd link,...

Hi Experts, I have 2Mbps line in which i want to give priority to video calls i.e H.323 and for voice calls and data (email , ftp ) lesser priority. For example if i 2 video calls are on and rest is occupied by voice calls or dat...

Is there any way to re-enable CDP on a 3650 after disabling LLDP? Normal commands don't work both at the global level and the interface level. CDP still fails to detect neighbors even though it shows an interface is participating. TenGigabitEthernet1...

I want to set up a monitor session on an interface that is connected to a IP phone (not a Cisco one). I am just curious to understand how it works with the monitor session with regard to the VLAN tagged traffic on that port. So the phone will have a ...

I am an independent security contractor working with a Cisco 3750-48PS and Trendnet TW-715 wireless access point setup. I have no access at this time to view any diagnotics of the switch in question and am trying to determine if the fault occuring is...

I have a stack of three 2960s using stack wise cables to make them into one logical switch.  I have two 4500x switches stacked via VSS. The 2960 top switch will be trunked to the 4500x top switch and the 2960 bottom switch will be trunked to the 4500...