Smart license command with the IOS 17.03.xx

[marzi]

hi all

I've installed a new C9200L-48P-4G and I've done an IOS upgrade 17.03.03 CAT9K_LITE_IOSXE.

I've activated the license too using smart license command.

I've seen that new commands are needed with IOS 17.03.xx.

For example :

previous valid command : Device# license smart trust idtoken <7y98676yyuy87ywqggeiue.....>

current valid command : Device# license smart trust idtoken <7y98676yyuy87ywqggeiue.....> all force.

The show license status is :
Smart Licensing Using Policy:
Status: ENABLED

but with the show version command I see the following:

Smart Licensing Status: Registration Not Applicable/Not Applicable

My question is:

With the IOS 17.03.xx shomething is changed about the smart license procedure ?
Is the Registration Not Applicable/Not Applicable inside the show version command correct ?

Thank and have a nice day

Fabrizio

[Mohsin Alam]

You can find all the changes here:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/release/17-3/configuration_guide/sys_mgmt/b_173_sys_mgmt_9200_cg/sl_using_policy.html

## Make sure to mark post as helpful, If it resolved your issue. ##

[marzi · Accepted solution]

Thank you very much

Best regards

Fabrizio

[KY_]

Hi

I have a same problem in cisco 4321 cube router with ios 17.3. so do i need to register cube smart software cloud ?

Does it mandotary  for uck9 license ?

Smart Licensing Status: Registration Not Applicable/Not Applicable

We only use uck9 license not cube session license.

Thanks

[DominikKristof]

I have same problem with C9500. Have you managed to resolve it?

[marzi]

Purtroppo è passato un po di tempo. Se non ricordo male usammo il metodo Call Home Service for Direct Cloud Access.
Il cliente permise al suo firewall di collegarsi a Cisco e la cosa funzionò.
Mi dispiace non esserti più di aiuto, ma se puoi utilizza il metodo Direct Clouds Access

good luck

Fabrizio

[marzi]

ops sorry I wrote in Italian language

Follow the translation

Unfortunately, some time has passed. If I remember correctly,
we used the Call Home Service for Direct Cloud Access method. The customer allowed his firewall to connect to Cisco and it worked.
Sorry I can't help you anymore, but if you can use the Direct Clouds Access method

Sorry again