SNMP Traps Question

[Patrick McHenry]

Hi -

I noticed on a router config under snmp traps

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server enable traps ds1

snmp-server enable traps tty

snmp-server enable traps flash insertion removal

snmp-server enable traps envmon

snmp-server enable traps ds0-busyout

snmp-server enable traps ds1-loopback

snmp-server enable traps ethernet cfm cc mep-up mep-down cross-connect loop config

snmp-server enable traps ethernet cfm crosscheck mep-missing mep-unknown service-up

snmp-server enable traps aaa_server

snmp-server enable traps bulkstat collection transfer

snmp-server enable traps memory bufferpeak

snmp-server enable traps config-copy

snmp-server enable traps config

snmp-server enable traps config-ctid

snmp-server enable traps dsp card-status

snmp-server enable traps dsp oper-state

snmp-server enable traps entity

snmp-server enable traps fru-ctrl

snmp-server enable traps event-manager

snmp-server enable traps ospf state-change

snmp-server enable traps ospf errors

snmp-server enable traps ospf retransmit

snmp-server enable traps ospf lsa

snmp-server enable traps ospf cisco-specific state-change nssa-trans-change

snmp-server enable traps ospf cisco-specific state-change shamlink interface-old

snmp-server enable traps ospf cisco-specific state-change shamlink neighbor

snmp-server enable traps ospf cisco-specific errors

snmp-server enable traps ospf cisco-specific retransmit

snmp-server enable traps ospf cisco-specific lsa

snmp-server enable traps cpu threshold

snmp-server enable traps ipsla

snmp-server enable traps syslog

snmp-server enable traps isakmp policy add

snmp-server enable traps isakmp policy delete

snmp-server enable traps isakmp tunnel start

snmp-server enable traps isakmp tunnel stop

snmp-server enable traps ipsec cryptomap add

snmp-server enable traps ipsec cryptomap delete

snmp-server enable traps ipsec cryptomap attach

snmp-server enable traps ipsec cryptomap detach

snmp-server enable traps ipsec tunnel start

snmp-server enable traps ipsec tunnel stop

snmp-server enable traps ipsec too-many-sas

Do these traps have to configured manually or are they enabled by default?

This is a config from a 2800. Would there be different snmp traps for a 1001 router?

Thanks, Pat

[Giuseppe Larosa · Accepted solution]

Hello Patrick,

I think there is an all option to enable all supported SNMP traps on device.

I guess that is the command that has been used here

The list of supported SNMP traps is platform dependent, so if you are moving to an ASR 1001 the list of traps will be similar but different in some items

Hope to help

Giuseppe