03-28-2011 01:36 AM - edited 03-06-2019 04:17 PM
Hi
I'm seeing an issue on 2 of my switches (6509 with SUP720b) where they dont seem to save comands to the running config. For example: If I edit the config of one of my 10Gb fiber interfaces with the follwing comands:
conf t
Int te9/1
switchport
switchport mode dynamic desireable
switchport trunk encapsulation negotiate
If I then do a "show run int te9/1" I only see the following config
switchport
The wierd thing is that if I do a "switchport trunk encapsulaion dot1q" then that IS saved to the running config.
I cant figure out why this would be the case? Any ideas would be greatly appreciated!
Thanks
John
Solved! Go to Solution.
03-28-2011 02:14 AM
Hi,
yes, generally: The default values are not visible in the Cisco config usually.
BR,
Milan
03-28-2011 02:00 AM
Im thinking that this is maybe default behavior?
03-28-2011 02:14 AM
Hi,
yes, generally: The default values are not visible in the Cisco config usually.
BR,
Milan
03-28-2011 09:04 AM
Thats correct , the default behavior is desirable for trunking mode and the encapsu
lation is negotiated so it will not show in config. If you change it to like switchport mode trunk it will
show up.
03-28-2011 09:41 AM
Thanks guys.
I guess I was worrying about nothing!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide