Source span port is te 1/1/3 but get information from gi 1/0/3 catalyst 9300

[Iforar]

 Have this settings:

"monitor session 3 source interface Te1/1/3
monitor session 3 destination interface Po1"

show interface te1/1/3

get:"TenGigabitEthernet1/1/3 is down, line protocol is down (notconnect)"

On the Po1 i get information from Gi 1/0/3

[marce1000]

 - Verify your running configuration , perhaps there is still another span-session defined somewhere.

M.

[Iforar]

I verify setting this source session number absent and after that I chang session number but get traffic from gi 1/0/3

[Iforar]

I verify setting this source session number absent and after that I chang session number but get traffic from gi 1/0/3

[balaji.bandi · Accepted solution]

Can you post the running config for the interface. including monitor session config.

[Iforar]

!
interface Port-channel1
load-interval 30
!
interface Port-channel2
load-interval 30
!
interface GigabitEthernet1/0/3
switchport access vlan 119
switchport mode access
spanning-tree portfast
!
interface GigabitEthernet1/0/17
load-interval 30
channel-group 2 mode active
spanning-tree portfast
!
interface GigabitEthernet1/0/18
load-interval 30
channel-group 2 mode active
spanning-tree portfast
!
interface TenGigabitEthernet1/1/1
channel-group 1 mode active
spanning-tree portfast trunk
!
interface TenGigabitEthernet1/1/2
channel-group 1 mode active
spanning-tree portfast trunk
!
interface TenGigabitEthernet1/1/3
!
monitor session 1 source interface Te1/1/3
monitor session 1 destination interface Po1"
monitor session 2 source interface Gi1/0/15 - 16 , Gi1/0/21
monitor session 2 destination interface Gi1/0/20
monitor session 2 destination interface Po2