I would advise against using bpdu-filter -especially using this on an trunk interface as its the same as disabling spanning tree and can result in stp loops.in you network.
This shouldn't be applied to any trunk interfaces.as you do expect to receive bpdu's
Please don't forget to rate any posts that have been helpful.
Please rate and mark as an accepted solution if you have found any of the information provided useful. This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Listen: https://smarturl.it/CCRS9E25 Follow us: twitter.com/ciscochampions
With applications and users everywhere, the networks are now, more than ever, being tasked with delivering consistent protection while providing an exceptional user exper...
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...