Stack C9500-24Y4C

[Jonmikhail102]

Hello,

I can build a stack of switches (C9500-24Y4C) with 3 interfaces HundredGigE and with remaining interface (HundredGigE) connect another switch?

In this moment it does not work, the connection to the other switch has the status "notconnect"

Thanks for your comments!

[Julio E. Moisa · Accepted solution]

Hi

You should have 2 ports for the stackwise virtual and the 3rd port used for Dual active detection, like shown below:

Now You could use the 4th port to connect the swith with other one as it is not part of the stackwise. If it is displayed as not connected you should verify the module, fiber, negotiation or speed on both ends. 

Regards