have a cable i think is bad, is it possiable to switch the cable out without causing any downtime to the switch or connected devices?
HQ-1st-Flr-Stack#show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 Down None 50 cm No No Yes 3 No
1/2 OK 2 50 cm Yes Yes Yes 1 No
2/1 OK 1 50 cm Yes Yes Yes 1 No
2/2 OK 4 50 cm Yes Yes Yes 1 No
3/1 OK 5 3 m Yes Yes Yes 1 No
3/2 Down None 50 cm No No No 3 No
4/1 OK 2 50 cm Yes Yes Yes 1 No
4/2 OK 5 1 m Yes Yes Yes 1 No
5/1 OK 4 1 m Yes Yes Yes 1 No
5/2 OK 3 3 m Yes Yes Yes 1 No
HQ-1st-Flr-Stack#