Stack port down on 3750

[jcounsell1222]

have a cable i think is bad, is it possiable to switch the cable out without causing any downtime to the switch or connected devices?

HQ-1st-Flr-Stack#show switch stack-ports summary

Switch#/  Stack   Neighbor   Cable    Link   Link   Sync      #         In 

Port#     Port              Length    OK   Active   OK    Changes   Loopback

          Status                                          To LinkOK         

--------  ------  --------  --------  ----  ------  ----  ---------  --------

  1/1     Down      None    50 cm     No     No     Yes        3        No

  1/2     OK         2      50 cm     Yes    Yes    Yes        1        No

  2/1     OK         1      50 cm     Yes    Yes    Yes        1        No

  2/2     OK         4      50 cm     Yes    Yes    Yes        1        No

  3/1     OK         5      3 m       Yes    Yes    Yes        1        No

  3/2     Down      None    50 cm     No     No     No         3        No

  4/1     OK         2      50 cm     Yes    Yes    Yes        1        No

  4/2     OK         5      1 m       Yes    Yes    Yes        1        No

  5/1     OK         4      1 m       Yes    Yes    Yes        1        No

  5/2     OK         3      3 m       Yes    Yes    Yes        1        No

HQ-1st-Flr-Stack#

[jcounsell1222]

the issue i am having is with a stackport not an eathernet interface. i dont think you can do a show int on a stackport. the output from the "show switch stack-ports summary" is above in my original post.