Stack wise 9300 switch /ports number

[mustafahaider7543]

Hello there,

Is there any way to get ports number appears like 48 ports in same slot (SW-9300-24P) started from (Gi1/0/1 to Gi1/0/48) , in my case the ports shown in the stack switches (Gi1/0/1 - 24  for active switch  , // Gi2/0/1 - 24 for the standby switch).
Thanks in advance,
Best regard.

[balaji.bandi]

No not possible -

what make difference for you either 1/0/1 or 2/0/1 Operation point of all work as expecrted ?

[mustafahaider7543]

Hi @balaji.bandi ,
Thanks for your reply,

In my scenario , I had one of the switches with SFP+ and I need to use it , because the second device doesn't have the SFP+ card I can't use the valid one. Is there any way help to use it ?

BR.

[balaji.bandi]

the port numbering not possible to change, that is fixed based on the switch model.

you need to change the higher port - as @Leo Laohoo also inline with my views

[mustafahaider7543]

Hi @balaji.bandi 

could you please explain more ? I didn't get you.

BR

[balaji.bandi]

No not possible - the way you thinking in the Orginal post

Only possible if you replace switch with 24 port to 48 port

the port-numbers are based on the switch model like 24 or 48 ports.

[M02@rt37]

Hello @mustafahaider7543,

No...The port numbering in a Cisco Catalyst 9300 switch stack is typically based on the physical location of the ports on each switch in the stack. If you have a 9300-24P model, which has 24 physical ports, you will see port numbers in the format "Gi1/0/1" to "Gi1/0/24" for the active switch and "Gi2/0/1" to "Gi2/0/24" for the standby switch in a two-switch stack.

[MHM Cisco World]

Use description by add manually or by eem each port number to 48.

[Leo Laohoo]

Change switch 1 to a 48-port switch.