Stackwise Standby removed

[Adnan Khan]

Hi,

I have two C9407 and configured in stackwise virtual. When I removed SVL and Dual active cables then Standby switch goes in recovery mode and in show switch output it shows as removed. When I connect the cables back then standby switch does not join the stack and remain as removed in show switch output. Any idea what could be the issue?

Regards,

[Mark Malone]

Hi Adnan
what way have you physically set this up , did you follow the guide , this issue has come up before please see this post it may help

https://community.cisco.com/t5/switching/cisco-9407-svl-testing-procedure/td-p/3869104