Stackwise virtual config is not allowed on provisioned switch/line

[Mr PSIT]

Hi All,

I have 2 new C9500-24Y4C switches with ver 17.09.04 and network advantage licencing. I followed the seemingly straight forward commands to setup the stackwise virtual but I am getting the above error when I run the command "Stackwise-virtual link 1 " on my chosen interface. This is happening only on my second switch. I am not sure if i did something wrong that has caused this. Any ideas would be much appreciated.

Stackwise virtual config is not allowed on provisioned switch/line cards.

Thanks

[marce1000]

 - Checkout this thread : https://community.cisco.com/t5/switching/cataylst-9500-40x-vss-distributed-stack-config-is-not-allowed-on/td-p/4141408

 M.

[Mr PSIT]

Thanks M. I did see this post. When I do a "Show Switch" on both switches it just shows Switch 1 active. There is no second switch there. That error  also starts with "Distributed Stack config is not allowed " where my error states "Stackwise virtual config is not allowed"

[Mr PSIT · Accepted solution]

Hi,

I got this sorted by resetting both switches using "write erase" and "no stackwise-virtual". I then reloaded and started again and all worked well. Happy Days!!  When I finished the stackwise-virtual config, I reloaded my first switch completely (let it reboot fully) before reloading the second switch. 

Thanks 

[Mr PSIT]

Hi All,

I have 2 new C9500-24Y4C switches with ver 17.09.04 and network advantage licencing. I followed the seemingly straight forward commands to setup the stackwise virtual but I am getting the above error when I run the command "Stackwise-virtual link 1 " on my chosen interface. This is happening only on my second switch. I am not sure if i did something wrong that has caused this. Any ideas would be much appreciated.

Stackwise virtual config is not allowed on provisioned switch/line cards.

Thanks

[ericnich]

Hello Mr PSIT. You posted this in the section for Data Center Switches, i.e., Nexus devices. I recommend moving it to the Catalyst section as they will be more informed on your question.

[Mr PSIT]

Thanks - I have moved it to the Catalyst section

[Rich R]

Merged this duplicate thread with the one above and moving entire thread to Switching not Catalyst Center.