08-03-2017 10:23 AM - edited 03-08-2019 11:36 AM
Dear sir
I have two core switches (3750 in stack).
Access Switch IE-3010.
ON THE ACCESS SWITCH CCTV CAMERA ATTACHED. THE L-3 VLAN IS CONFIGURED ON CORE SWITCHES.
DEFAULT ROUTE IS CONFIGURED ON ACCESS SWITCH TOWARDS CORE SWITCHES.
I HAVE CONFIGURED THE STORM CONTROL UNICAST , MULTICAST, BROADCAST LEVEL 65 - 87 ON TRUNK PORT IN & OUT. INTERFACE LIKE ACCESS TO CORE TRUNK LINK ONLY.
NOW ISSUE IS THAT HOW TO DECIDE THE PARAMETERS OF STORM CONTROL LEVEL.
HOW TO CHECK THE STORM CONTROL TRAFFIC ON INTERFACE FOR PARAMETERS.
I HAVE CHECK THE COMMAND :-
SHOW INTERFACE GIG X/X COUNTERS
IS THERE ANY TOOL FOR PMEASE SUGGEST.
THANKS & REGARDS
RAJ SINGH
Solved! Go to Solution.
08-28-2017 02:17 PM - edited 08-28-2017 02:21 PM
Hi
There is no recommended o best practice levels, It it is evaluated by the network administrator and the services or programs working over the network, some websites say it should not be more than 20% for broadcast, below you will find a link that could be useful:
Also check the TAC answer on this link:
https://supportforums.cisco.com/t5/lan-switching-and-routing/storm-control-thresholds/td-p/707264
Hope it is useful
:-)
08-28-2017 02:17 PM - edited 08-28-2017 02:21 PM
Hi
There is no recommended o best practice levels, It it is evaluated by the network administrator and the services or programs working over the network, some websites say it should not be more than 20% for broadcast, below you will find a link that could be useful:
Also check the TAC answer on this link:
https://supportforums.cisco.com/t5/lan-switching-and-routing/storm-control-thresholds/td-p/707264
Hope it is useful
:-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide