09-14-2008 01:34 AM - edited 03-06-2019 01:22 AM
Will a 2811 running 12.4(11)X/Advanced-Enterprise-Services route between sub interfaces?
I can't get traffic from f0/0.50 to route to f0/0.100. Both interfaces have IPs and are doing dot1q trunking.
Traffic from both these interface can route to f0/1.
09-14-2008 02:08 AM
Can you post the interface config , probably something with that . It should route fine between subinterfaces , probably the trunk isn't setup correctly between the router and switch. If possible post the switch config also.
09-15-2008 08:44 PM
It works now. I had to enable NAT on one of the interfaces. thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide