Switching

Hi, I have just recieved a SPF to install into my C3750 switch to provide me with a gigabit trunk to a C2960.DO I just push the SPF in and that is it? The switch is on and live, so I'm not sure if I have to down this switch first?Thanks

Is there any way that i can make my PC act as a Router...?IF yes wat are the steps needed for..Need all your kind intervention..

HiHi I have tried evaluation license to 3750E base image to IP service . When i install license i am getting the following error. Switch#copy tftp flash:Address or name of remote host [1.1.1.3]? Source filename [FD01136V06N_20081206022514333-ips]?...

Hi all.I connect remote office via dlc modem and cisco 851 router and can't limiting bandwich on WAN (FastEthernet4) interface.I use following config for FastEthernet4:!interface FastEthernet4 description $FW_OUTSIDE$$ES_WAN$ bandwidth 320 ip address...

I have 4500 switch configured vlans. i want to connect server which has to two NIC cards. Each NIC card has to connect different switch but same vlan. But we are getting %C4K_EBM-4-HOSTFLAPPING messages frequently. This says between trunk and servert...

Hi,Is it advisable to use two ip helper-address in my network? And if possible how will set it up?Thanks.

My PC class consist of line LAN, and wireless LAN. can we help me, tune up the network, or show me a example with the help i can tune up singly/

Hi all,UDLD What type of UDLD will I apply for the below links. What is Cisco best practice for UDLD in a layer 2 topology?a.Etherchannel(L2) ports between the Core switches.b.Trunk dot1q uplink ports from edge switches to Core switches.c.Trunk dot1q...

windows VISTA not obtaining IP from router(DHCP)DHCP is configured in the router and all the Windows XP and win98 systems are able to obtain IP from DHCP. but windows vista is unable to obtain IP from DHCP. We have tested the same Vista laptop with a...

Hello! I am trying to vlan a 3548 switch so that I can put all my public-facing devices (isp router, firewall and ASA) on this switch. I cannot get the isp device to come up on the switch. I have disabled portfast, set duplex settings to 100 full,...

Hello,I would like to clarify a question about Protocol Independent Multicast which operates in a Dense mode. As stated by RFC 3973, PIM is a protocol which is used between the _routers_ in order to ensure multicast packets routing and forwarding in ...

Hi.What is the MAXIMUM number of STANDBY routers in ONE HSRP group?Danny.

Ok, is it just me or does finding IOS images on Cisco.com very confusing.I have a CCO account and have been tyring to find an updated image for the 3560.Is there a tutorial that shows you how to navigate through this maze? Thanks.