02-15-2011 10:35 AM - edited 03-06-2019 03:34 PM
Hello,
I'm preparing for core switch upgrade (new 4506E chasis with Sup7E) and have questions:
1.does the engine come with IOS installed?
2.does the engine come with license or perhaps I need to buy it?
3.is there instalation/configuration manual available (I can't find it) - unfortunately I don't have experiance with core switches, so I need as much info as possible.
thank you
forman
02-15-2011 10:44 AM
1) Yes, the IOS come installed.
2) What license? You can receive a document, but lot of features licensed will work whitout any check.
3) Try it http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/01xo/configuration/guide/config.html
02-15-2011 11:04 AM
Thanks. I've just installed the sup in the chassis and powered it on. It went into rommon and states that "peer supervisor not detected or is not running IOS"?? You mentioned that it should come with IOS preloaded. Can you advise?
thanks
02-15-2011 11:24 AM
Try insert this commands in rommon:
flash_init
boot
May be your supervisor is without IOS...
Have you 2 supervisor?
Remove one and try boot again.
You can ready this documents too
http://www.cisco.com/en/US/docs/cable/rf_gateway/feature/guide/rfgw10_1pls1sup.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide