12-25-2019 06:43 AM
Hi everyone,
I need explain about config SLV on C9600:
1. When SVL group links down, By DAD link, act switch convert to Act Switch-Recoverry mode, Stanby Sw- active. But SVL up why act sw-recoverry mode cannot switch back to the original.
2. As Cisco document, default SVL is etherchannel, why I unplug 01 SVL link Stanby switch reload ? I config 02 link on 01 switch to group link SVL.
Thanks and Regrards,
TD
Solved! Go to Solution.
12-25-2019 02:43 PM
Hi,
1. When SVL group links down, By DAD link, act switch convert to Act Switch-Recoverry mode, Stanby Sw- active. But SVL up why act sw-recoverry mode cannot switch back to the original.
That is by design, so there is never loop on the network.
2. As Cisco document, default SVL is etherchannel, why I unplug 01 SVL link Stanby switch reload ? I config 02 link on 01 switch to group link SVL.
Unplugging one of the SVL links should not reload the active or the standby switch.
This maybe a bug or a config issue.
HTH
12-25-2019 01:42 PM
Any body help me ?
12-25-2019 02:22 PM
Hello,
to partially answer your question: I think there is no mechanism to 'preempt' (similar to HSRP) the active SVL switch. The logical reason I can think of for that is that, since both SVL switches are of the same model, software version and license level, a preemptive switchback would only increase the downtime and not have any advantage.
12-25-2019 02:43 PM
Hi,
1. When SVL group links down, By DAD link, act switch convert to Act Switch-Recoverry mode, Stanby Sw- active. But SVL up why act sw-recoverry mode cannot switch back to the original.
That is by design, so there is never loop on the network.
2. As Cisco document, default SVL is etherchannel, why I unplug 01 SVL link Stanby switch reload ? I config 02 link on 01 switch to group link SVL.
Unplugging one of the SVL links should not reload the active or the standby switch.
This maybe a bug or a config issue.
HTH
12-25-2019 06:51 PM - edited 12-25-2019 07:37 PM
Here is config. Pls review help me
stackwise-virtual
domain 2
interface twentyFiveGigE 1/1/0/45
stackwise-virtual link 1
interface twentyFiveGigE 1/2/0/45
stackwise-virtual link 1
interface twentyFiveGigE 2/1/0/45
stackwise-virtual link 1
My version:
Cisco IOS XE Software, Version 16.11.01
Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.11.1, RELEASE SOFTWARE (fc3)
interface twentyFiveGigE 2/2/0/45
stackwise-virtual link 1
12-27-2019 05:50 AM
Thanks for supporting, I upgraded to new version 16.12.02 (before 16.11.01). All problem is resloved.
12-27-2019 09:16 AM
Hi,
Thanks for the update. I guess it was bug in the version you were running.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: