SW Catalyst Express 500 Series

[Translator]

I want to add my SW Catalyst Express 500 Series In my network park I found two problems:

1-It's impossible to have telnet to configure with putty

2-How to activate trunk mode on a port with the web assistant to see communicate with other Cisco switches

Thank you!!!!!!

[Jitendra Kumar]

SwCE500 switch does not support CLI.

you can define the port role by GUI for the trunk snap attached to see if it helps you.

Thanks,

Jitendra

Thanks

[MaryF14]

Hi! Can you please send again the configuration you mentioned in your previous post (response)?

Thank You!

Mary F.

[Georg Pauwen]

Hello,

you have to assign the smartport role 'Switch' to the port:

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-express-500-series-switches/70485-cat-exp-500-config.html#single_port