Switch ports doubt

[bern46]

Hello,

I have a Cisco 2960 with 24 ports and 2 additional SPF+ ports.

When checking the configuration, I see a total of 26 GigabitEthernet and also 2 TenGigabitEthernet ports. Total of 28 ports.

Is it possible that port 25 and 26 are those TenGigabitPorts but configured as Gigabit ?

Thanks and regards.

[Kasun Bandara]

it should be combo ports. what is the switch model. share output of #sh ver

[bern46]

It's WS-C2960X-24TD-L. I've seen both with 2 and 4 sfp ports. This one has 2

Thanks

[balaji.bandi]

its dual mode ports you can use for 1Gig and 10Gig SFP on that ports. so you need to use either gig or tengig ( so totaly only 26 ports)

[bern46]

So it's normal they appear twice as Gig and TenGig ports ?

Thanks for the fast replies.

[MHM Cisco World]

can I see show interface status ?

[Kasun Bandara]

if you can share exact model number, we can tell exact supported and count of ports

[balaji.bandi · Accepted solution]

yes its normal nothing to worry on that (but dont count as 28 ports, only 26 ports)

[bern46]

This is shown in show verion (note it's a stack of 2)

52 Gigabit Ethernet interfaces
4 Ten Gigabit Ethernet interfaces

And interface status shows port 25 and 26 configured as 1Gig:

Gi1/0/25 connected trunk a-full a-1000 1000BaseSX SFP
Gi1/0/26 pc + VoIP notconnect 1 auto auto 1000BaseSX SFP

Is it normal that show running-config still displays the TenGig port even they're configured as Gig?

[MHM Cisco World]

friend there are two physical  Ten port in each SW 
the port are 
24 port + 2 multi Gig port + 2 Ten ports 
the total number you will see 
48+ 4 = 52 gig port 
4 Ten ports 
for both SW. 

[Kasun Bandara]

without seeing exact model number i cannot say the 100% accuracy of this. but it seems like 2960X 24 port with 2 SFP+ ports. so config will show 2 SFP+ ports as tengigs. some switches have 2 port configurations for 1 and 10gig. this can be like that.

[bern46]

@Kasun Bandara The model number is WS-C2960X-24TD-L Do you need anything else ?

@MHM Cisco WorldThe first I did is to check physically on the switch and there are 24 ports + 2

Thanks guys.

[MHM Cisco World]

here what you see ? are there any SFP in slot show in photo ??

[Kasun Bandara · Accepted solution]

@bern46 correct. as i guessed. if you plugged 10G-SR, you need to configure tengig interfaces and if you plugged 1G SFP, you can configure gig interfaces,

[MHM Cisco World]

@bern46 can you share 
show  show interface transceiver details <<-
if you can, I need to see how SW show both speed for one port. 
thanks