Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,We currenlty have a stack of two Cisco Meraki, with a total of 3 VLANS configured. Port 3 of the active Meraki is serving default Vlan1 and Vlan9Port 4 of the Meraki is serving Vlan10This 2 ports are going to a Core switch, first one a...
Hello,I have a Cisco 2960 with 24 ports and 2 additional SPF+ ports.When checking the configuration, I see a total of 26 GigabitEthernet and also 2 TenGigabitEthernet ports. Total of 28 ports.Is it possible that port 25 and 26 are those TenGigabitPor...
Hello,In our company we just configured a new host with an IP from a specific VLAN. When trying to ping from the normal LAN everything is fine, but when we do it from another subnet we lose some packets.Do you know what could be happening ?
Hello,I'm doing some tests with a 1941 router and setting up dhcp.While inside a dhcp pool I get an error with the lease command:router(config)#ip dhcp pool NET1router(dhcp-config)#lease 10^% Invalid input detected at '^' marker.Also the clear ip dhc...
Hello everyone,I'm kind of new on networking and I'm trying to understand this behaviour:I have two switches let's say S1 and S2, port 1 and 2 of each switch is connected to the other one with link aggregation. Then port 3 of both S1 and S2 it's conn...
Hi Flavio,It doesn't look like a compatibility issue. Both Core switches are also from Cisco and as I mentioned I have the exact same config in another place and it works fine.Thanks anyways.
Hi guys,Changed the priority to set Core switch as root for Vlan 1 and nothing.Meraki port is configured with Vlan1 as default and Vlan9 as allowed.Core switch port has Vlan1 as native and Vlan9 as allowed, with default encapsultation 802.1QI have an...
Note that Cores are also cisco.The trunk port without encapsulation and the access port connecting from the Core to the meraki without STP.I checked the spanning tree and the root is poiting to another port where there's another switch.
@Kasun Bandara The model number is WS-C2960X-24TD-L Do you need anything else ?@MHM Cisco WorldThe first I did is to check physically on the switch and there are 24 ports + 2Thanks guys.
This is shown in show verion (note it's a stack of 2)52 Gigabit Ethernet interfaces4 Ten Gigabit Ethernet interfacesAnd interface status shows port 25 and 26 configured as 1Gig:Gi1/0/25 connected trunk a-full a-1000 1000BaseSX SFPGi1/0/26 pc + VoIP n...
