Switch SG350 as a DHCP server

[Okami11]

Good morning 

I have a Cisco Switch SG350-28P PoE managed switch. I have enabled  it and configured it as a DHCP server, IPV4 pool range 192.168.1.101 to 192.168.1.130, however. the first PC I connected does not get the IP from th switch but from the router ( provider )   from which the switch is connected. What am i doing wrong and how can I fix it ? thanks for your help.

[balaji.bandi]

Hope you Looking to get IP address from the Switch not from the provider:

then DHCP config look at the below document :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350-series-managed-switches/smb5406-configure-dynamic-host-configuration-protocol-dhcp-snooping.html

[Okami11]

Thanks for your answer. I will check the document and comeback to you. 

[Kasun Bandara · Accepted solution]

Hi,

there is few options. below 2 are the quickest and easiest.

1. disable DHCP server in provider router. (having two DHCP servers in same network creates unpredicted IP assignments and conflicts)

2. create separate network between provider router and SG350 switch without using same user network. (or vice versa)

regards,

KB

please rate and mark solution if this solved your concern

[Okami11]

Thanks , I will try your solutions.