06-13-2016 12:57 PM - edited 03-08-2019 06:10 AM
Hello Experts...
I tried everything I knew to fix an issue with vlan but I cannot. I suspect that there is a missing word switchport that should be in the configuration. I am referring to the word "switchport" by itself under the interface. Should I see there or is it okay not to see it? I had this issue before but I was able to fix it after a reboot but not this time. Thanks for all your help in advance.
Config from a working switch:
Core1#show run interface gi 1/13
Building configuration...
Current configuration : 101 bytes
!
interface GigabitEthernet1/13
switchport
switchport access vlan 300
switchport mode access
end
Config from a non working switch:
Stack2#show run interface fa 1/0/13
Building configuration...
Current configuration : 88 bytes
!
interface FastEthernet1/0/13
switchport access vlan 300
switchport mode access
end
Solved! Go to Solution.
06-13-2016 01:22 PM
Hi,
Its ok not to see it. As long as you have for example:
switchport access vlan 300
switchport mode access
It is switch port and it is in access mode.
HTH
06-13-2016 01:47 PM
just to add to Rezas point , if you run show int f1/0/13 switchport it will state its access aswell or trunk if set as trunk
06-13-2016 01:22 PM
Hi,
Its ok not to see it. As long as you have for example:
switchport access vlan 300
switchport mode access
It is switch port and it is in access mode.
HTH
06-13-2016 01:47 PM
just to add to Rezas point , if you run show int f1/0/13 switchport it will state its access aswell or trunk if set as trunk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide