switchport mode access

[jspsumit8880]

difference between two commands

switchport mode access

sw access Vlan 10 and switch port access Vlan 10. what will happen if switchport mode access command missing on the switch

[MHM Cisco World]

I dont get which commands ypu want to compare 

And for using only 

Switchport access vlan <x> 

This command do two things 

1- make port as access port without need of switchport mode access 

2- assign vlan<x> to this port 

MHM

[M02@rt37]

Hello @jspsumit8880 

Switch-Port Mode—Specifies whether the port is an access port connected to an end device or a trunk port for uplink connectivity. Access VLAN—Specifies the VLAN id for the port, when the switch-port mode is access.

-- Native VLAN—Specifies the VLAN for incoming untagged packets, when the switch-port mode is trunk