Hi All,We are having a weird issue and while we wait on Cisco TAC to evaluate I thought of polling the community.In this set up we have two ISR router in a HSRP group. They are connected to two Catalyst 9300 with a port channel between them.We config...
Forum Posts
Hi all,So long time reader first time poster. I have inherited a bit of a mess and mish mash of a network. My main issue is that I can not ping a subnet (VLAN300) 192.168.0.0/23 from the server stack 172.25.1.0 (VLAN200) however I can ping fine the o...
Resolved! Float routing beetwen 2x WS-C4500X-32
I have two WS-C4500X-32 switches interconnected via 2x Pear 2 Pear connection with different ISPs.There are two paths setted with different Distance metrics. Therefore when I shutdown the interface with low metric, the routing table don't change aut...
Does sharing my thoughts and asking questions are the same operation?
Hi,My C2960-16PS-LL port always disable. This port connect to access point AIR-AP280 via gig0/1.Error:10/24/2022 10:05:59 AM Error 32: Interface GigabitEthernet0/15, changed state to up10/24/2022 10:05:59 AM Error 33: Interface GigabitEthernet0/16, c...
does etherchannel cause multicast packets to be received out of sequence, gapping, duplicate..etc ??? in general, would etherchannel affect multicast traffic ?
Dear Sir,I have problem with the C9200 log discriminator setting. It seems the length of the paramter is liminted to 40 characters.Could you tell me what can I do if I want to filter additional messages ? This is the current setting , the character h...
Good Day,I am current having issue whereby the macsec is not working between 9500 cisco 17.x.x on Layer 2. I used the below configsmka policy (name)macsec-cipher-suite gcm-aes-256exikey chain (***) macseckey 1000cryptographic-algorithm aes-256-cmacke...
How to configure span port on CBS250-8P-E-2G
. The requirementsof this design are summarized as follows:• The building has three floors.• There are 300 user workstations and 10 servers.• Users must be grouped according to the projects they’re working on, but the users foreach project are locate...
I have a stack of two 3850's configured with an int vlan 17 and we access that switch via an IP on that vlan. However, I configured a new vlan 777, and with that new vlan I can ping out but can't ping it from outside other networks/subnets/devices. T...
Dear Cisco Community Team,I would like some help and guidance on fixing an issue I have with 2 Cisco 6513 switches.The 2 Cisco 6513 switches are working as my data center switches connecting most of our systems to it.The CPU have been spiking multipl...
Hi all,Do we know how often the output of the show command "show power" is updated ? What is the time interval that is used to update the results ?
